logging into actiontech 3200m via wifi
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Link to Post
- Email to a Friend
- Report Inappropriate Content
can this be done, or is it only hard wire that is supported. i don't see any option to enable this when i login ?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Link to Post
- Email to a Friend
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Link to Post
- Email to a Friend
- Report Inappropriate Content
As far as I know the only restriction to accessing your router is that you connect from a local IP address. This would be a 192.168.x.x address.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Link to Post
- Email to a Friend
- Report Inappropriate Content
The T3200M GUI can be access by going to 192.168.1.254 within your browser of choice ( Should work on anything)
Username is admin
Password is on the sticker. Don't use the Wifi password but use admin password.
Let me know if that help you out, bud.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Link to Post
- Email to a Friend
- Report Inappropriate Content
i can login to the router only via hard wire ethernet cable. not over the wifi? is that by firmware design? i know some routers don't allow remote access via wifi for security reasons. i don't see any option to enable this when i am logged into the admin console.