Forum Discussion
Solved
Technicolor NH20T
I switched from Shaw to Telus PureFibre a little while back and had a Technicolor NH20T installed. As I already had a TP-Link Deco XE75 mesh system set up, it was easier to just put the NH20T in brid...
- I didn't think you will be able to reach the NH20T from your LAN if it's in bridge mode. I'm not familiar with that device but if bridge mode works on specific ports then you should try connecting to the other ports instead.
Never mind, just figured out that the NH20T comes apart in TWO sections.
If you pull the sides of the unit, one part is exposed that has zero information on login, but if I open from the BOTTOM, then a cover comes off and voila, login info! Haven't tried yet, but assume it is correct.
Figured this out from here - https://www.reddit.com/r/telus/comments/u5v8rv/comment/ilw4z9j/
So I finally got around to getting a USB network adapter and plugged it into one of the gigabit ports of the NH20T.
If I leave DHCP on, I get an IP and have internet access.
If I set a static IP of 192.168.1.50, I can go to 192.168.1.254 and get to the login screen.
The unit does NOT have any login credentials on it, unless they are on the back of the unit where it is mounted to the wall? admin and password doesn't work - I think those were defaults for the NH20A
