Forum Discussion
Solved
DFS Channel Selection Frustration
Good day all. This post is part rant and part question. Short version; I live in a condo which means WiFi channels are crowded, even the 5GHz band U-NII-1 and U-NII-3 are busy. I've seen upwards of ...
stonehorse Wrote: So here are the questions, is there a way to 'force' DFS channel selection?
I looked into doing the exact same thing when we first acquired Telus fibre a couple years ago. Unfortunately no way is possible to force a T3200M to allow this configuration. It just isn't in any of the configuration menus.
The only solution that I was able to find is a far more expensive method for the consumer.
1. Connect your fibre directly to a aftermarket router, such as one from the Ubiquiti line.
2. Utilize a Media converter and output that signal to a consumer router.
Both of these methods incurred additional cost, however, it seems to be the only solution that I was able to find... Cheers...
If you find this post useful, please give the author a "Solution", or mark as "Kudo", if it solves your problem, thank you very much.
I live in an urban area around 10km from airport - I get hits very fast on a few channels but on others I have been pretty much for more than a month and its fine.
