Can I change out 2 wifi 6 Telus boosters with different routers?

[chillguy]

I wanna be able to use the deco wifi mesh system and I’m upgrading the routers because the ones from Telus are really buggy and I hope I can get the deco wifi mesh system to connect with the Telus NH20T modem/ ont. How would I set it up?. 

[TELUS_Support]

You could always check in with our Tech Support team to see if they could assist, though as you'd be discussing third party equipment it may be outside the scope of support.

[Rocky3]

---

@chillguy wrote:

I wanna be able to use the deco wifi mesh system and I’m upgrading the routers because the ones from Telus are really buggy and I hope I can get the deco wifi mesh system to connect with the Telus NH20T modem/ ont. How would I set it up?. 

---

The Telus NH20T is the network hub. From there ethernet goes to the boost 6 WIFI and then to the two boost (relays) that you appear to be talking about. 

If your mesh system starts at the hub NH20T with ethernet I can see it working. Thing is, where does the buggy issue start, I think it is the hub, maybe even the modem. Brief loss of internet is mentioned quite a bit here. So I wondered if it could be buggy with the deco mesh too.

My NH20T is sitting flat on shelf, yesterday I took off the cover to expose the ventilation holes. It runs much cooler, maybe a solution.