Forum Discussion
Solved
Qolsys IQ Power Barrel Connector Spec
Replacing my 2 year old DSC wired system with TELUS Qolsys wireless alarm system, I want to mount my Qolsys remote panels in the same place my DSC panels were removed from but need to splice in a 90 ...
I'll answer this question myself, I ordered from DigiKey 3 each of the Tensility International Corporation "CBL ASSY 1.7MM PLUG-CBL FLAT 6'" and DigiKey part # CP-2198 ND. They're 4mm in diameter with a 1.7mm opening, with barrel approximately 9.3mm long, they appear to be the correct ones to complete my wiring to power the Qolsys panels from my mechanical room and they were $3.99 each...
I'll answer this question myself, I ordered from DigiKey 3 each of the Tensility International Corporation "CBL ASSY 1.7MM PLUG-CBL FLAT 6'" and DigiKey part # CP-2198 ND. They're 4mm in diameter with a 1.7mm opening, with barrel approximately 9.3mm long, they appear to be the correct ones to complete my wiring to power the Qolsys panels from my mechanical room and they were $3.99 each...
Just adding information, today I verified the wiring back to the old wired distribution panel, discovered the wiring going directly to my new remote panels and tested them to see if battery charging for the new panels was OK, and it was all good, except I only have 2 - 22 gauge wires per negative & positive voltages, the other 2 were going to the old magnetic switch(es). Tomorrow will get some nice wooden backing plates, router out holes to store the wiring, and will mount all the goodies to my front and back door positions...
