Forum Discussion
Solved
Technicolor NH20T
I switched from Shaw to Telus PureFibre a little while back and had a Technicolor NH20T installed. As I already had a TP-Link Deco XE75 mesh system set up, it was easier to just put the NH20T in brid...
- I didn't think you will be able to reach the NH20T from your LAN if it's in bridge mode. I'm not familiar with that device but if bridge mode works on specific ports then you should try connecting to the other ports instead.
Never mind, just figured out that the NH20T comes apart in TWO sections.
If you pull the sides of the unit, one part is exposed that has zero information on login, but if I open from the BOTTOM, then a cover comes off and voila, login info! Haven't tried yet, but assume it is correct.
Figured this out from here - https://www.reddit.com/r/telus/comments/u5v8rv/comment/ilw4z9j/
New TELUS install and I have the Technicolor NH20T. I have asked TELUS to help me enabled bridge mode but they are telling me it is not possible. The new firmware doesn't allow this due to security reasons. Anyone else know about this? I want to use my router/setup as I have many things configured all I need to bridge mode enabled.
