User Profile
MrFiber
Organizer
Joined 11 months ago
User Widgets
Contributions
Re: New Telus PureFibre installation Quebec
Hey Peter, I have tested my connection but currently I’m limited to 1 gig due to my gear. Which is approximately is 940 mbps on actual speed test. Now if your getting into technical specs yes your connection can support 1.5gig. Now if your actually going to get 1.5gig is not technically possible due to overhead connection bandwidth that your router is using. In my experience I’ve only gotten 1.5 gig speedtest on only one connection which is rogers, however I’m guessing that they don’t do speed limiting to each client.3.9KViews1like0CommentsRe: New Telus PureFibre installation Quebec
Hey Peter, I'm currently using the Ontario service of telus pure fibre, and have bypassed the NHA20 by using a fiber media converter. WARNING, this will only give you ipv4 as of now and NO IPV6. Here is the link to the one I used. You are going have to set all the PPPOE and VLAN settings as follows, VLAN ID: 40 Priority: 0 802.1q tag: yes Be sure to use the SFP module provided to you by the tech4.3KViews1like7CommentsRe: Bridge mode not working??
Hey, I'm currently a new customer for telus fiber in Ontario. The bridge mode is currently not working for me and I'm using a fiber media converter from amazon. This only gives me ipv4 and no ipv6. If you want the fiber media converter I'm using your going to have to get your PPPOE credentials from customer support. Fiber Media Converter893Views0likes0CommentsRe: NHA20 not giving Wan to my router in Bridge Mode
Hey everyone, I'm now currently running a different setup using a Fiber media converter which give my deco internet. I have one problem though, I can't see to Ipv6 to work and I've tried basically every thing the configuration to try and get a IPV6 address. Could anyone help me out?2KViews0likes0CommentsNHA20 not giving Wan to my router in Bridge Mode
Hello so I've just gotten the new Telus service here in Ontario. I use the Deco X-50 Poe as my router as I have mesh Wifi system. I've put the NHA20 in bridge mode but it doesn't provide a Wan IP to the router. I've tried factory reseting and then trying again, it didn't work then either. I've been using Dynamic IP settings on my X50-Poe but it doesn't work. It only works when the router is plugged in without bridge mode but that limits features of the router. I've also tried to just plug in my laptop when it is bridge mode and I can't pick up a connection then either. Could someone help solve this very odd issue as this is the first time I'm encountering this.2.3KViews0likes10Comments