User Profile
Machound
Neighbour
Joined 2 years ago
User Widgets
Contributions
Re: Honeywell Redlink
Thanks for this alternative solution. I logged into the NAH panel and turned bridge mode off and entered the revised Gateway IP address as above and saved the settings and then just rebooted the NAH and once the NAH was back online after a minute the whole Wifi and Optic TV systems worked fine and the Honeywell RedLink device also works and responds within 30 secs to any change in settings from my phone app (failure the respond was the original problem that Honeywell couldn't solve) so this is a very good / better solution.1.4KViews0likes0CommentsRe: Honeywell Redlink
I want to highlight the solution again for newcomers to this complicated thread. My Honeywell red link stopped working after my wifi upgrade to wifi6 smart modems. Strangely I could get it to work briefly for 5 mins at a time after a complete system reboot and plugging it’s Ethernet cable into either the NAH or the boost wifi modem. But then it would loose internet connection each time. The solution as described in this thread is to access the admin panel for the NAH then find the LAN settings and turn on bridge mode for one specific port (which you can do for lan port 1 using the small drop down selection). Then after the Nas reboot just plug the Redlink Ethernet into this LAN port 1 (you might have to switch an existing cable to another port to free it up). At last my redlink system works again!2.8KViews1like0Comments