Neighbour
•
1 Message
Closed
Using Ce Smart Plugs with the new TELUS Fiber Modem and Wireless AP devices
Hey all, I've been struggling a lot as of late to get my CE Smart Wi-Fi plugs back on my network since being converted over to TELUS Fiber and being handed a bunch of new equipment (a new Router and a new separate AP Wireless Device (the White Cylinder).
These worked on my previous setup right up until the conversion so I am ruling out faulty devices.
The app is installed on my Android phone called: CE Smart and it scans looking for the device.
I have connected a device to a single extension cord, suppling power to it it and can turn it off and on at will.
Each CE Smart plug is only supported on 2.4ghz and so I connect my phone to SmartHome1901 2.4ghz SSID. No issues connecting my phone to this SSID.
Pressing and holding the only button on the Smart Plugs for about 10 seconds initiates the Pairing mode and I do see the Blue link light flashing as I am supposed to.
A countdown starts for 2 minutes and nothing seems to register. I've tried so many times.
Here's hoping someone out there has figured out how to connect these devices to the new TELUS equipment. Any support or help or suggestions will be greatly appreciated. Thanks.
Discussion
•
Updated
7.6K
4
0
0
Top Contributors
View MoreTELUS_Support
+22 more
Community Manager
•
8.1K Messages
FuzzyLogic
+25 more
Community Power User
•
1.8K Messages
Coach
•
30 Messages
Community Stats
Total Posts
Total Members
Total Posts with Accepted Solutions
Accepted Solution
DrPacman
+12 more
Rockstar
•
SpaceAce68 Wrote: Each CE Smart plug is only supported on 2.4ghz.
There has been a discussion regarding this matter in the forums previously. You may want to check this thread out regarding temporally turning off the 5.0Ghz network, and connecting your devices, then changing it back to a dual band network.
Thread linked here: https://forum.telus.com/t5/Internet-Home-Phone/How-do-I-set-up-a-2-4-ghz-network-on-my-5-ghz-Telus-Hub-Modem/m-p/112192#M27186
If you find this post useful, please give the author a "Solution", or mark as "Kudo", if it solves your problem, thank you very much.
0
Bartsch_Labs
+3 more
Friendly Neighbour
•
Another thing you might want to try before adjusting the access point is factory-resetting the smart plug.
From: https://support.cesmarthome.com/en/support/solutions/articles/44000568540-how-to-factory-reset-the-smart-plug
If your Smart Plug is not connected to the CE Smart App, follow the below steps to initialize the blue flashing LED:
0
Aworldintime
Neighbour
•
0
Aworldintime
Neighbour
•
1