enb54
+4 more
Advisor
•
44 Messages
Qolsys IQ Power Barrel Connector Spec
Replacing my 2 year old DSC wired system with TELUS Qolsys wireless alarm system, I want to mount my Qolsys remote panels in the same place my DSC panels were removed from but need to splice in a 90 degree barrel connector for the 7 volt DC power. Does anyone know the spec for the barrel connector so I can try to get a pigtailed version from an electronics supplier? I really don't want to cut them off the existing power cables but I will if I have to. Thanks in advance for any help...
Discussion
•
Updated
5.9K
3
0
0
Top Contributors
View MoreTELUS_Support
+22 more
Just Moved In
•
8.1K Messages
594
FuzzyLogic
+25 more
Just Moved In
•
1.8K Messages
66
Coach
•
30 Messages
30
Community Stats
Total Posts
Total Members
Total Posts with Accepted Solutions
Accepted Solution
enb54
+4 more
Advisor
•
I'll answer this question myself, I ordered from DigiKey 3 each of the Tensility International Corporation "CBL ASSY 1.7MM PLUG-CBL FLAT 6'" and DigiKey part # CP-2198 ND. They're 4mm in diameter with a 1.7mm opening, with barrel approximately 9.3mm long, they appear to be the correct ones to complete my wiring to power the Qolsys panels from my mechanical room and they were $3.99 each...
0
0
breanna34
Neighbour
•
When splicing a barrel connector for your Qolsys wireless alarm system, it's essential to get the correct specifications to ensure compatibility and safety. Since you're replacing a DSC wired system, examine the DSC panels or wiring to see if they have any information regarding the voltage and polarity of the power supply. This can serve as a reference point for your Qolsys system. Armed with the correct specifications, visit an electronics supplier or store specializing in connectors and accessories. Provide them with the OD, ID, voltage, and polarity details to find the appropriate barrel connector.
3
0
enb54
+4 more
Advisor
•
A final word on this project, I have successfully mounted the remote keypads at my front and back doors using the existing wiring to carry the 7 volt DC power from our basement utility room where the DSC wired control panel/power supply was mounted previously. The outside of the barrel connector (for remote's power) is the negative voltage while the inside pin is positive, check this BEFORE you connect to your remote panel or you'll likely blow out the electronics in the remote panel. Attached is a photo showing our remote mounted at the front door and the IQ Panel 4 is now mounted in an upstairs bedroom location, much more convenient for us...
1 Attachment
20230924_180714[1].jpg
0