ET's profile

Rockstar

 • 

458 Messages

Closed

Bridge Mode - Using Your Own Router

What Is Bridge Mode?

When you sign up for TELUS internet, you will receive a device called a gateway — a two-in-one modem and router combo. Bridge mode is a feature that allows a user to disable the router side of the gateway (i.e., Wi-Fi) and use a third-party router in its place.

TELUS currently offers bridge mode on three gateway models: the T1200H, T2200H, and T3200M. The main difference between these models is that the T1200H is a single-line gateway, while the T2200H is a copper-bonded gateway used for higher-speed plans where two lines are required.

Setup

  1. In the address bar of your browser, type 'http://192.168.1.254' and press Enter
  2. The Gateway’s Home screen will appear. Enter your username and password, then click the Wireless Setup icon located in the top row of icons (see below).

   

   3. Click on Advanced Setup on the right side.

   4. Click on Port Bridging.

   5. The Port1 Bridge screen will appear (see below) - click Enable and then click Apply.

 

 

2 Attachments

This conversation is no longer open for comments or replies and is no longer visible to community members.

Neighbour

 • 

1 Message

Just a follow up question: When bridging, do I need to use lan port 1 on telus modem/router to connect to my router (ie. since it says port1 bridge)?

Neighbourhood Alum

 • 

455 Messages

CoachRuss Yes, that's correct - port 1 is the only port that bridges.

 

Cheers,

 

ScottyJ

Organizer

 • 

11 Messages

Very informative.. 

Neighbour

 • 

3 Messages

Hi, I just set up my R7000 and did the bridging on the T2200H myself. After bridging, Is it a correct setup that I can still see and connect to the T2200H wi-fi connection? Or should I turn the wifi off in the T2200H

 

Thanks.

Advocate

 • 

3.2K Messages

If using your own router disable the Wifi Radio on the T2200H.

 

*Keep in mind anything that was connected wirelessly to the T2200H will lose it's connection. You will have to enter the new WiFi network settings to connect to the R1700.

 

*If you ever need to connect to the Actiontec you will require a hard wired connection to configure settings (since the wifi radio is turned off).

Top Contributors

View More

Community Stats

Loading...

Total Posts

Loading...

Total Members

Loading...

Total Posts with Accepted Solutions

Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...