Neighbour
•
1 Message
[URGENT] Boost Wi-Fi 7 (B02E) Cannot Obtain Public IP in NAH Bridge Mode
I'm trying to optimize my Telus PureFibre network by setting my Boost Wi-Fi 7 device as the primary router to manage my Mesh network effectively.
My current topology relies on the NAH -> Coax Adapter -> Boost 7 link.
The Problem:
NAH Successfully Bridged -> Boost 7 Fails to Connect
- NAH Status (Network Access Hub):
- I successfully accessed the NAH interface and set the Local Port Mode to Full Bridge Mode.
- The NAH indicator light is green, confirming the bridge is active and routing/DHCP is disabled on the NAH.
- Boost 7 (B02E) Status:
- The Boost 7 is connected via the Coaxial Adapter link.
- It is failing to obtain a public IP address (stuck on connecting/error). The indicator light is red.
Steps I Have Already Taken:
- Confirmed the NAH is in Full Bridge Mode.
- Performed a complete power cycle on the Boost 7 (unplugged for 1 minute).
- Confirmed the connection is from the Coax Adapter to the Boost 7's WAN/Internet port.
- Tried restarting the modem after the change.
Any advice on the authentication/handshake process for the Boost 7 in a bridged environment would be greatly appreciated.
Thank you for your help!
Discussion
•
Updated
415
2
0
0
Top Contributors
View MoreTELUS_Support
+22 more
Community Manager
•
8.1K Messages
FuzzyLogic
+25 more
Community Power User
•
1.8K Messages
Coach
•
30 Messages
Community Stats
Total Posts
Total Members
Total Posts with Accepted Solutions
Nighthawk
+28 more
Community Power User
•
If the Wifi 7 Boost is the same as the Wifi 6 models, the Boost units are NOT ROUTERS. The NAH is the router and the Boost units are merely wireless access points. They won't work if directly connected out over a bridged connection.
0
0
snowface
Friendly Neighbour
•
Try first connecting the bridge port to PC and see if the bridge port works on single device. After that as Nighthawk has mentioned, you do need a router if connecting more than one device coz Boost is just an access point.
1
0