gigabituser1234
+1 more
Organizer
•
15 Messages
Closed
Switch and Router Connected Directly to ONT
Hey everyone,
I have had an idea brewing for a bit now on how to fix the Wi-Fi upstairs. Long story short, we have a pretty big house that's been finished already. The previous owners only wired the first floor for Ethernet, and I've already ran a 100ft cable downstairs to the basement from the router to hard wire there. That leaves the upstairs above the garage basically a dead-zone for wireless. I'm talking speeds of around 1mbps when we have internet 750.
So anyways, my idea was to connect port one of the ONT to a dumb switch that I have already, which then connects to a Nightgear R7000 setup in AP mode via the LAN port. I would still be using the T3200M and the Optik TV boxes as well. So basically it would go like this:
ONT -> Switch -> R7000 in AP -> T3200M -> DLink in AP
Quite a bit confusing, but please do let me know if you notice any glaring issues right off the bat. I've tried it once and made it work properly, we get speeds of 400Mbps upstairs now with pings of less than 5ms but I want to make sure I'm not exposing any security flaws or something along those lines to the outside.
Thanks for your time everyone!
Discussion
•
Updated
17K
2
0
0
Top Contributors
View MoreTELUS_Support
+22 more
Just Moved In
•
8.1K Messages
590
FuzzyLogic
+25 more
Just Moved In
•
1.8K Messages
66
Coach
•
30 Messages
30
Community Stats
Total Posts
Total Members
Total Posts with Accepted Solutions
Accepted Solution
gigabituser1234
+1 more
Organizer
•
I ended up just replacing the T3200M entirely with the R7000 instead. Wi-Fi speeds upstairs are improved in the dead-spots before, but still could be alot better. I'll probably end up using the mesh network like you mentioned. Either that or do a couple cable drops in the house to improve the connection upstairs.
Either way thanks to everyone for your guys input, it definitely helped push me in the right direction!
Cheers.
0
0
Nighthawk
+28 more
Just Moved In
•
Can't quite figure out how you're going to connect things. Is it:
+-- R7000 | ONT -- Switch --+-- T3200M | +-- Dlink APor
ONT -- Switch --+-- R7000 ->-> T3200M | +-- Dlink AP?
One problem I could see is if you connect the R7000 directly to the ONT/Switch in AP mode is that the devices connected to the R7000 will all be trying to pull external IPs and there won't be a firewall since no router. That would be bad for security and also Telus usually limits the number of external IPs on a residential account to 2.
If you want the devices in your house to be able to communicate with each other, you need a router before the APs. The config I had was Modem > T3200M > (LAN4) > Router. All my personal devices ran off the router which was running default settings as a router and not an AP. The Optik boxes were directly connected to the T3200. I had no issues on my personal devices in that configuration, even with gaming.
15
0