Dougie65
+1 more
Friendly Neighbour
•
6 Messages
Closed
Cat6 pre install wiring
I asked this earlier on the wrong forum I think. My Telus installer is coming in a week and I want to run Cat6 to the attic two stories up for a network closet. There, I’ll have the router/modem. Not sure how many Cat6 I should run. Not sure if PVR can stay near OTC, so I need two lines up I guess at least.
Discussion
•
Updated
6.9K
3
0
0
Top Contributors
View MoreTELUS_Support
+22 more
Community Manager
•
8.1K Messages
FuzzyLogic
+25 more
Community Power User
•
1.8K Messages
Coach
•
30 Messages
Community Stats
Total Posts
Total Members
Total Posts with Accepted Solutions
DrPacman
+12 more
Rockstar
•
Dougie65 Wrote: I want to run Cat6 to the attic two stories up for a network closet. There, I’ll have the router/modem. N
Good day,
As I interpret your wiring requirements. I gather that you'll have the Telus supplied Modem/Router in a lower level of your house. From that lower location you'll be suppling your Optik Tv via the MoCa outlet on the Telus device and the preexisting cable network throughout the house. Ok, so that aspect is now covered.
The run of Cat6 will be utilized to supply an aftermarket router that will reside in the attic, is this correct? If that is a correct assumption, the Telus device will ne to be put into bridged mode to feed that aftermarket device. So only 1 run of Cat6 would be required to enable that task.
Now the next question I would ask, is do you plan on linking a switch up in your attic to feed additional locations within your house via hardwire. If that is indeed a requirement then, obviously each of those runs would need to be feed from the attic to the various locations.
If your going the utilize only wireless access throughout the house, a high power router with wireless capability would be spec'd to handle those requirements.
If I missed the jist of your thought here, I apologize, and hope you can specify a little... Cheers...
If you find this post useful, please give the author a "Solution", or mark as "Kudo", if it solves your problem, thank you very much.
3
xray
+25 more
Advisor
•
The attic is probably not the best location for your router for WiFi coverage. The centre of the house on the middle floor is best. If you are installing a mesh network then that's a different story and I would recommend running ethernet cable to your mesh node locations as well.
1
0
xray
+25 more
Advisor
•
Ah, got it. I hope you are using cable rated for in-wall use. Outdoor cable isn't necessarily the same as it has more to do with being waterproof that being fire resistant.
1
0