how can i get the remote to "forget" an aux. device?

Reply

This thread's discussion is locked. If it doesn't give you the information you need, head to its forum board for active discussions or to start a new discussion.

Highlighted
Resident

I want to forget my amp on my slimline remote. how can this be done, as i just want to control volume through the tv itself?


Accepted Solutions
Highlighted
Most Helpful
Ambassador

Hi,

You would need to perform a Factory Reset on your remote.

 

Here are the instructions:

 

**Before starting this process, the TV mode must be selected.** To confirm, please press the Mode button until the light next to TV is on.

1) Press Options for a minimum of 3 seconds. LED will flash Twice.

2) Enter code 1000. LED will flash Twice

 

This will set the remote back to factory resetting and it will only work with the TELUS digital box until reprogrammed.

View solution in original post


All Replies
Highlighted
Most Helpful
Ambassador

Hi,

You would need to perform a Factory Reset on your remote.

 

Here are the instructions:

 

**Before starting this process, the TV mode must be selected.** To confirm, please press the Mode button until the light next to TV is on.

1) Press Options for a minimum of 3 seconds. LED will flash Twice.

2) Enter code 1000. LED will flash Twice

 

This will set the remote back to factory resetting and it will only work with the TELUS digital box until reprogrammed.

View solution in original post