This thread's discussion is locked. If it doesn't give you the information you need, head to its forum board for active discussions or to start a new discussion.
I am on my 3rd actiontec 3200 modem and still have exactly the same problem. Almost everyday (usually in the late evening) the 2.4g network goes down and only comes back when I power cycle the router.
I have fibre to house and this happens to laptops, androids and an Ipod.
I set up a ping from my desktop (hardwired to the modem) to my laptop and normally it only took a few milliseconds for the ping response, but sometimes I would see response times up to 3 seconds to timeout. Then I would eventually see network unreachable. This morning I disabled and re-enabled the 2.4g on the modem (192...) and this worked for a few minutes, but then went down again. Has anyone else seen this problem. Telus 2nd level techs tell me I am the only place they have seen it.
I am willing to try any suggestions to solve the issue.
No, but a number of us in the neighbourhood have installed a separate router to operate our local network due to varied challenges with the 3200.
The telus tech has offered to install a 2.4g only repeater to "solve" the problem. To me this is plain and simple poorly tested firmware. I am running a vanilla environment. There are 7 different devices that may go in and out of range every day. Two laptops, 5 cell phones. There is an ipod that sits in its cradle that is only 2.4g
@DonMarquardt Unfortunately the only real recourse right now is using your own router. The 3200 handles the Optik tv side, our routers for everything else.
The T3200m works great for some people and not so great for others. One would assume the manufacturer has been made aware of various issues. We just have to wait for newer firmware.
Of course, Actiontec does not want to be responsible to provide support for every ISP that has created their own firmware. No surprise.
Hadn't thought of it that way. If actiontec was wanting to keep a good reputation they would supply firmware that could be minimally configured by the isp and they would supply the "real" workings.
I had a similar problem with the 3200 - and enabling Smart Steering seemed to cure the problem. Basically smart steering let me use just a single SSID name and then the 3200 "steered" the connecting device to the appropriate frequency band. So maybe that might solve your issue too - basically let the 3200 figure out what is best for the client.
I'm having the exact same issues at 2.4 not 5. Mainly on the second tv which is in the back bedroom of a basement suite. So I assume it's because it's location. I'll try the smart steering though! Thanks guys! I hope that fixes it
I've installed Ethernet to all locations in my home where an Ethernet connected device is placed. Wi-Fi is used only for non-wired devices. I strongly recommend wired over wireless.
Doesn't work too well for a cell phone or Ipod. My wife's phone and my Ipod are only 2.4 G I use the Ipod for streaming music.
Still no luck. I am going to be seeing another Telus tech tomorrow. I don't expect any real solution. I am quite willing to be a beta site for the modem to try and resolve the issue. I have been told I am the only place this is happening. As we can see from above this is not true.
Did tech support have you shut off band steering on the T3200M and see how that worked?