Forum Discussion
Using 2 routers and IP Address
I am posting this wondering how anyone who puts a switch between their ONT and routers manage to get around the issue of only having 1 IP Address? I have internet 150/150 and there's only 1 IP Addres...
Good afternoon…
I’m following this discussion with great interest. I as well would like to enable a second public IP on my system. Utilizing the T3200M modem/Router in Bridged mode, are we not able to utilize the second LAN port to issue a second public IP address?
I was able to utilize the second LAN port on my Shaw modem to facilitate this ability when the modem was in bridged mode…
DrPacman My issue is actually wondering if my own router as a 2nd IP is fine. Apparently telus told me they only issue 1 IP which would be connected to my Actiontec right now. So when I bridge the connection with my own router, my own router would then be the 2nd IP.
I had a few issues where I would disconnect and had to reset both routers to get a wan connection again, but my own router would have issues after reset while actiontec router would be fine, so I'm not sure if it is because it has trouble getting a 2nd IP address. Or if it was just my setup before with the switch in between.
Using other LAN ports besides LAN 1 on the t3200m I hear wouldn't work on a port bridge as Telus only allowed LAN 1 to work from my understanding.
Do it this way:
If you are using ONT modem:
From the ONT you need to a have network switch, at least 5 port network switch the smallest that you can buy. Connect the switch to the ONT modem port 5 of the switch. Then you can connect your 2 routers to any of the remaining 4 ports. This of course if the sub-net of the ip address that TELUS assigned to your modem is at least 255.255.255.252, means that this sub-net is allowing you to use 2 use-able ip addresses. To tell you frankly, don't rely on what the technical support from TELUS tells you right away since most of the them are level 1 support and doesn't know everything about TELUS infrastructure. stinger, yes the ip address of the second router should be fine for as long as the sub-net is at least 255.255.255.252.
I have this exact set up going from the ont to a gigabit switch, and then out to a linksys router and tp link router. Everything works great and then after a few hours, the internet disconnects on the tp link router.
Tried the same set up with the telus 3200 and linksys and the same internet connections cuts off on the telus 3200 but holds on the linksys.
If i reset the router that dropped the connection it works for a couple hours then drops the internet connection again.
Any idea what is going wrong here?
