Forum Discussion
Solved
Technicolor NH20T
I switched from Shaw to Telus PureFibre a little while back and had a Technicolor NH20T installed. As I already had a TP-Link Deco XE75 mesh system set up, it was easier to just put the NH20T in brid...
- I didn't think you will be able to reach the NH20T from your LAN if it's in bridge mode. I'm not familiar with that device but if bridge mode works on specific ports then you should try connecting to the other ports instead.
Never mind, just figured out that the NH20T comes apart in TWO sections.
If you pull the sides of the unit, one part is exposed that has zero information on login, but if I open from the BOTTOM, then a cover comes off and voila, login info! Haven't tried yet, but assume it is correct.
Figured this out from here - https://www.reddit.com/r/telus/comments/u5v8rv/comment/ilw4z9j/
New TELUS install and I have the Technicolor NH20T. I have asked TELUS to help me enabled bridge mode but they are telling me it is not possible. The new firmware doesn't allow this due to security reasons. Anyone else know about this? I want to use my own router/setup as I have many things configured all I need to bridge mode enabled.
Awesome. Wonder if my firmware will get updated automatically and screw up my whole install. Painful.
Were you able to access the settings to be able to see the bridge mode enabled. Also what firmware does your box shows? Maybe I can ask TELUS to push that firmware as I have the same hardware. I am sure they will tell me its not allowed.
- No, I gave up when it became clear how dumbed down the interface was. I will upgrade my Deco routers to multigig ethernet interfaces when the price comes down a bit.
