Forum Discussion
Solved
Switch and Router Connected Directly to ONT
Hey everyone, I have had an idea brewing for a bit now on how to fix the Wi-Fi upstairs. Long story short, we have a pretty big house that's been finished already. The previous owners only wired ...
I ended up just replacing the T3200M entirely with the R7000 instead. Wi-Fi speeds upstairs are improved in the dead-spots before, but still could be alot better. I'll probably end up using the mesh network like you mentioned. Either that or do a couple cable drops in the house to improve the connection upstairs.
Either way thanks to everyone for your guys input, it definitely helped push me in the right direction!
Cheers.
You are correct, that would give you separate networks which I'm guessing you don't want.
If your goal is to increase WiFi coverage then go with what Nighthawk recommended in a previous post and configure the R700 for Access Point mode. That will give you 1 network with 2 separate SSID's.
ONT Port 1 -- WAN of T3200M --- LAN4 connected to WAN on R7000
A better alternative is to use the TELUS Boost WiFi instead of the R7000 in the above configuration which will give you a mesh network with 1 SSID.
https://www.telus.com/en/ab/mobility/accessories/product/telus-boost-wi-fi-starter-pack
I ended up just replacing the T3200M entirely with the R7000 instead. Wi-Fi speeds upstairs are improved in the dead-spots before, but still could be alot better. I'll probably end up using the mesh network like you mentioned. Either that or do a couple cable drops in the house to improve the connection upstairs.
Either way thanks to everyone for your guys input, it definitely helped push me in the right direction!
Cheers.
How did your setup go? ONT directly to the R7000? Or ONT to switch to R7000?
I have IGMP proxying enabled which allows Optik to work perfectly. I'll look into alternative firmware though if I run into any problems in the future.
Check your Optik service to make sure it's still working properly with the R7000. It needs multicast turned on.
I have a R7000 sitting on the shelf. It was decommissioned because the Netgear firmware was terrible. If you are running an alternative firmware like Merlin then it should be better.
