Forum Discussion
Solved
PureFibre ipv6 own router issues
I have PureFibre with my own router plugged directly into nokia ont. this works fantastic with ipv4, 0 issues! until I enable ipv6 in my router. It's able to get the ipv6 no problem and it works for ...
On opnsense or pfsense you can run “/sbin/rtsol -a”, or replace the “-a” with the interface name for the WAN (igb0 or whatever it is). If you do this every 20 minutes or so it should keep the route active.
I can run CRON jobs in Opnsense but am not to sure where to get started with this. Do you have any resources you could point me to so I could fix this issue?
On opnsense or pfsense you can run “/sbin/rtsol -a”, or replace the “-a” with the interface name for the WAN (igb0 or whatever it is). If you do this every 20 minutes or so it should keep the route active.
Thanks! I will look into it
