NH20T Network Access Hub - Bridge Mode

Thanks very much for all the info! I went ahead and bridged the NAH. I think what may have been causing the extra IP on Telus’ end was an extra device I had plugged directly into the NAH, as Pattydee3 suggested. I’ve now connected it wirelessly to the eero, which should hopefully prevent this issue.

This brings up another issue. Any time I enable bridge mode, once the NAH restarts, the status LED is gone. Under system settings, the slider is off and greyed out, and attempting to change it gives me an “invalid instance” error message. I’ve gone through a few factory resets, which re-enables the LED - but as soon as I bridge the NAH the light goes out again. Is this possibly intentional to draw a tech’s attention to the fact the NAH settings have been messed with? Anyone else notice this? This might be worth it’s own topic…