Forum Discussion
Solved
IPV6 Help
I'm trying to set up IPv6 connection on an T3200M but I'm only getting "No network access" error. I'm not sure where else to start to get this fixed (called and they said they didn't know either).
Also using a D-Link DGS-105 switch and an Alcatel-Lucent modem (at least I think it is).
The following settings were followed:
IPv6 WAN Settings
IPv6: Dnabled
WAN IPv6 IP Protocol: DHCPv6
Request PD Only: Yes
IPv6 DNS Type: Default Servers
IPv6 LAN Settings:
LAN Connection Type: stateless
ULA Support: disable
Subnet Number: 0
Delegated to LAN: No
Have you checked with your school about IPv4 connections? It would be uncommon to see IPv6 only. If not, a free service like CloudFlare Warp has allowed others in the past to connect to IPv6 from an IPv4 connection.
7 Replies
- Nighthawk
Community Power User
All the Alcatel ONT does is convert fibre to ethernet. Are you on a residential or business connection? IPv6 has not been available on business connections. On residential, IPv6 should be automatic on the T3200M if it's available in your area. I know it shouldn't matter with a simple switch, but if you connect the T3200M directly to the ONT, do you see IPv6 addresses on the Connection Status page under the Status icon?
Would I have to call Telus to see why the IPv6 WAN status is disconnected?
- Nighthawk
Tech support may not have an answer for that seeing as how there is a working IPv4 connection. Previously there were some instances or regions where IPv6 wasn't available but I'm not sure if thats the same or if it has changed. You also didn't answer if this is for a home internet connection or a business one. Business connections have been known to not have IPv6. Is not having IPv6 affecting your connection?
Lan1 on the ONT is connected to the WAN port on the T3200M. This is what it currently shows:
