Forum Discussion
Solved
Honeywell Redlink
Redlink thermostat and bridgeing Hi I saw solutions about enabling bridge mode for the Redlink thermostat connection issue. I tried the solution about enabling bridge on Lan Port 1. But did not wor...
I want to highlight the solution again for newcomers to this complicated thread. My Honeywell red link stopped working after my wifi upgrade to wifi6 smart modems. Strangely I could get it to work briefly for 5 mins at a time after a complete system reboot and plugging it’s Ethernet cable into either the NAH or the boost wifi modem. But then it would loose internet connection each time. The solution as described in this thread is to access the admin panel for the NAH then find the LAN settings and turn on bridge mode for one specific port (which you can do for lan port 1 using the small drop down selection). Then after the Nas reboot just plug the Redlink Ethernet into this LAN port 1 (you might have to switch an existing cable to another port to free it up). At last my redlink system works again!
I want to highlight the solution again for newcomers to this complicated thread. My Honeywell red link stopped working after my wifi upgrade to wifi6 smart modems. Strangely I could get it to work briefly for 5 mins at a time after a complete system reboot and plugging it’s Ethernet cable into either the NAH or the boost wifi modem. But then it would loose internet connection each time. The solution as described in this thread is to access the admin panel for the NAH then find the LAN settings and turn on bridge mode for one specific port (which you can do for lan port 1 using the small drop down selection). Then after the Nas reboot just plug the Redlink Ethernet into this LAN port 1 (you might have to switch an existing cable to another port to free it up). At last my redlink system works again!
