Forum Discussion
Actiontec T3200 Bridge
Actiontec 3200: port 1 is in bridge mode and wifi is disabled.
My wifi router is hardwired to port 1 via ethernet.
Everything is working fine.
Whether I am connected to wifi on my router or connected via ethernet, I would still like to access clients/nodes that are hardwired into port 2 3 4 on the actiontec.
What do i need? vlan?
Thanks.
1 Reply
Replies have been turned off for this discussion
- NFtoBC
Community Power User
You could remove the bridge. Then all ports would be on the same network. Just set your additional router as an access point.
