Forum Discussion

vanmayung's avatar
vanmayung
Neighbour
12 days ago

NH20A 10G Bridge Issue

I'm on the PureFibre 3G plan and I've been trying to setup bridging so I can use my OPNsense router but I can't get it to connect to >1G speeds. Using the default settings (using the NH20A as a router) has no issues with 10G connectivity and I get multi-gig speeds.

Things I've tried:

  • Setting the NH20A to 10G Only and FULL Bridge, both still only communicate at 1G
  • Used a 10G and 2.5G NIC on the router but still only connects at 1G
  • Manually setting the port to 10GBaseT in OPNsense, does not work
  • Factory resetting multiple times
  • Yes, it's connected to the 10G Port on the NH20A

I'm pretty stumped at what else I can try.

1 Reply

  • TELUS_Support's avatar
    TELUS_Support
    Icon for Official Support Team rankOfficial Support Team
    11 days ago

    It seems you've done everything right. You've connected it to the right 10G port, and when you've connected to the Access Admin panel at 192.168.1.254 and logged in to configure and enable bridge mode, everything should be good to go. It is advised using Partial Bridge Mode or 10G Port Bridge rather than Full Bridge mode to maintain management access to the modem. Then a reboot should get you going. Can you confirm that you're still unable to get it to work? Let us know and we can send you a private message to discuss further.

Related Content